Headlight Bulb Replacement - Tracker Off-Road XTR1000 Operator's Manual


NOTE: If the screen is damaged in
any way, it must be replaced.
3. Install the spark arrester assembly
and secure with the cap screw.
Tighten to 96 in.-lb.
Headlight Bulb
Replacement

NOTE: The LED strips in the
headlight assembly are not individ-
ually replaceable. The entire assem-
bly must be
component.
To replace the headlight bulb, use the fol-
lowing procedure:
1. Remove hood.
2. Remove the wiring harness connector
(A) from the back of the headlight
bulb (B).
3. Rotate the headlight bulb (B) counter-
clockwise to remove from the assem-
bly.
4. Rotate the new headlight bulb (B)
clockwise into headlight assembly.
Reinstall wiring harness connector
(A).
5. Adjust the headlight using the Check-
ing/Adjusting Headlight Aim instruc-
tions in this section.
54
WC929
replaced as
XX069
Headlight Assembly
Replacement

NOTE: The LED strips in the
headlight assembly are not individ-
ually replaceable. The entire assem-
bly must
component.
To replace the headlight assembly, use
the following procedure:
1. Remove hood.
2. Remove the headlight retaining knob.
a
3. Remove the wiring harness connec-
tors. Remove the retainers on both
sides of the headlight assembly that
secure the headlight assembly.
4. Headlight assembly mounts in a "C"
shaped channel. Slide headlight
assembly toward the rear of vehicle to
release from the channel.
be replaced as a
XX069A
XX070
XX071