Displaying Controller Information - Adaptec xw4100 Software User's Manual

To display a controller's automatic rebuild on replacement status,
use the controller show automatic_failover command.
In the following example, rebuild on replacement is indicated as
DISABLED.
AAC0> controller show automatic_
Executing: controller show automatic_
failover
Automatic
To enable automatic spare, use the controller set
automatic_failover command with the /failover switch, as in
the following example:
AAC0> controller set automatic_failover
/failover_enabled=TRUE
Executing: controller set automatic_failover
/failover_enabled=TRUE
After running the controller set automatic_failover
command, use the controller show automatic_failover
command to verify that automatic rebuild on replacement has been
enabled. If necessary, you can now replace a failed disk with a
replacement disk.

Displaying Controller Information

Controllers exhibit a number of attributes that you can display or
manage using the following CLI commands:
controller list
■
Controller Attribute:
controller (adapter) name
controller (adapter) type
controller availability
Example of controller list:
CLI> controller list
Executing: controller list
Adapter Name
------------
\\.\AAC0
DISABLED
Adapter Type
------------
Adaptec xxxxx
Using the Command Line Interface
failover
failover
Indicates:
Name
Product name
Access mode
Availability
------------
read/write
4-9