Evinrude 4906B 4HP 1969 Owner's Manual page 373

9-38 HAND STARTERS
the special tool is not available take a stiff
piece of wire; insert it through the handle;
thread it through the rope; apply just a little
oil to the rope; then pull the wire and rope
through the handle.
14-
Work the end of the rope into the
handle anchor. Secure the rope in place by
pushing the anchor into the rubber handle.
15-
Lightly pull on the rope to relieve
tension on the pin installed
pulley and housing in Step 12.
some tension on the rope, remove the pin,
and allow the spring to
rope onto the pulley.
through the spindle to be sure it is tight.
16-
Lay the starter
the rope with quick movements,
same time check the pawls to be sure they
move towards the
Release the rope slowly and check to be
sure the pawls return to their original posi-
tion under the retainers.
through the
Maintain
SLOWLY wind the
Check the bolt
its
on back and pull
and at the
center of the pulley.