Evinrude 4906B 4HP 1969 Owner's Manual page 310

21- Check to be sure the water pickup
tubes are clean, smooth,
corrosion. Coat the water pickup tubes and
grommets with lubricant
lation. Guide the lower unit up into the
exhaust housing with the water tube sliding
into the rubber grommet of the water pump.
Continue to work the lower unit towards the
exhaust housing, and at the same time ro-
tate the propeller shaft as an aid to indexing
the driveshaft splines with the crankshaft.
22- Insert the bol t into the connector.
TAKE TIME to read
"Good Words" just before
and free of any
as an aid to instal-
and understand the
Step 20, before
MANUAL SHIFT 28 HP TO 40 HP
making this connection.
place, install and secure
the attaching hardware.
Start the bolts securing the lower unit to
t he exhaust housing.
EVENLY and ALTERNATELY.
23- Install the rear cover over the ex-
haust housing on some 35 hp and aU
engines. When the cover is installed,
to be sure the idle relief rubber tube on the
upper side underneath
into the recess of the cover.
cover in place with the attaching
24- Fill the lower unit with lubricant.
Insert the lubricant
opening, and then fill the unit until lubricant
is visible at the vent hole.
8-51
After the bolt is in
the window with
Tighten the bol ts
4-0 hp
check
the powerhead fits
Secure the
hardware.
tube into the bottom
Install the vent