Evinrude 4906B 4HP 1969 Owner's Manual page 254

1/4-
more than forward, the cutout switch
attached to the armature plate will open the
circuit to the starter solenoid.
ing system fails to operate the starter prop-
erly when the throttle
position, check the 20-ampere fuse between
the ingition switch
ammeter GEN terminal.
If the starter operates
(which it should not do), check for a short
between the two white leads in the shift box
wiring.
Further problems in the cranking system
may indicate more serious problems.
Chapter 6, starter motor sections.
DISASSEMBLING
The throttle cable and switch box may
be replaced without removing the shift box
from the boat. If the only service to be
performed is replacement
leave the shift box in place.
1- Remove the Phillips screws on the
side plate of the shift box.
front side cover.
2- Notice the screw and retainer at the
forward end of the casing guide and just
below the throttle lever.
and retainer. Pull the throttle
casting guide free of the shift box.
care not loose the trunion caps, one on the
top and another on the bottom.
3- Remove the screws from the end of
the casting guide and then pull the throttle
cable free. TAKE CARE
screws and sleeve from the end of the guide.
Shift Switch Removal
4- Remove the four Phillips screws from
the top of the shift box, and then lift off the
shift box cover around the push buttons •
••
AJS
IX PLACES)
If the crank-
lever is in the IDLE
BAT terminal and the
at full throttle
See
of the cable,
Remove the
Remove the screw
cable and
Take
not to loose the
S CREW
PUSJ-IBUTTONSHIFT BOX
5- Pull upward and remove
push buttons. New buttons are not supplied
with replacement
SAVE the THREE BUTTONS
with the new switch.
6- Pull the red, green, and blue wires
from the bottom of the switch box.
7- Notice the two small Phillips screws
on top of the switch box holding the switch
to the retainer. Remove these two screws.
8- Work the switch out of the switch
box.
(FOUR PLACES)
the three
switches. Therefore,
for installation
SCREW
7-21