Evinrude 4906B 4HP 1969 Owner's Manual page 110

and slip the spring over the edge of the
float, as shown. Apply just a drop of oil to
the inlet needle and then lower the needle
into the seat. Install
included in the kit.
15- Hold the carburetor
position, as shown, and observe the attitude
of the float. The float
(parallel) with the surface of the carburetor.
If the float is not level, use a pair of needle-
nose pliers and CAREFULLY
tab SQUARELY until
correct position (level with the carburetor).
Check to be sure the float is square with the
carburetor cavity (one side is not further
away than the other).
16- Place the bowl gasket in position on
the carburetor, and then position the bowl
on top of the gasket.
place with the five screws.
a NEW hinge pin
in a horizontal
must be level
bend the float
the float is in the
Secure the bowl in
FLOAT
-:
J/E
17- If a filter is used in the float bowl,
slip the filter down over the center
the bowl. Slide the gasket
float bowl. Install
secu ring the filter in place.
18- Place the glass float bowl in position
on top of the gasket.
place and secure it with the thumb nut.
19- Insert three
into the high-speed and low-speed cavities.
CARBURETORS 4-19
post in
into place in
and tighten the nut
Swing the hinge into
new packing washers
FilTER
NUT
FilTER