Evinrude 4906B 4HP 1969 Owner's Manual page 334

lift the lower unit into place with the drive-
shaft indexing wi th the crankshaft
and the water tubes entering
housing grommets.
have an assistant rotate
so slowly
CLOCKWISE
tric shift cable through while the lower unit
is being mated with the exhaust
Rotating the flywheel will permit the drive-
shaft to index with the splines of the crank-
shaft. Coat the threads of the attaching
screws with sealer.
faces of the exhaust housing and the lower
unit have made contact,
securing the two units together.
the screws alternately
40-
Feed the electric shift cable through
the inner exhaust cover until the cover is in
place on the surface of the exhaust housing.
Secure the cover in place with the two
attaching screws. A REMINDER:
screw also holds the damp used to secure
the shift cable in place.
41-
Install the rear housing cover with
the exhaust relief boot fitting into the re-
cess of the cover. Secure the cover in place
with the attaching hardware.
42- Position the outer exhaust cover in
place on the port side.
place with the attaching hardware.
43- Connect the shift
harness at the back of the engine, BLUE-to-
BLUE and GREEN-to-GREEN.
rubber protective sleeves in place over the
connectors.
splines
the exhaust
It may be necessary to
the flywheel ever
and to pull the elec-
housing.
After the mating sur-
start the screws
Tighten
and evenly.
The upper
Secure the cover in
wires to the
Slide the
ELECTROMATIC SHIFT
Exhaust housing with
the Shift wire clamp properly installed.
Propeller Installation
A FEW GOOD WORDS
The propeller washer and drive pin play
an extremely important role.
gears during normal
propeller should hit an underwater obstacle,
the propeller is subjected
shock. A washer is installed
propeller and drive pin. This washer
always be in place for proper operation.
the hub should slip, the propeller will move
back towards the propeller
against the drive pin. The washer is design-
ed to stop propeller movement so the drive
pin can be easily removed for service.
on with the installation.
the inner plGte installed
When shifting
operation, or if the
to considerable
between the
MUST
nut and lock
Now,
8-75
and
If