Evinrude 4906B 4HP 1969 Owner's Manual page 183

5-24 IGNITION
revolution and again check the gap adjust-
ment. After the crankshaft
and the points are on the high point of the
ca m, check to be sure the hold-down screw
is tight against the base.
clearance to allow the eccentr ic on the base
points to turn. If the hold-down screw is
tightened AFTER the point adjustment
been made, it is very likely the adjustment
will be changed. Follow the same proce-
dure and adjust the other
Remove the nut from the crankshaft.
Flywheel Installation
18- Check to be sure the flywheel mag-
nets are free of any metal parts.
19- Place the key in the crankshaft key-
way. Check to be sure the inside taper of
the flywheel and the taper on the crankshaft
are clean of dirt or oil,
flywheel from "walking" on the crankshaft
while the engine is
f lywheel down over the crank;haft
keyway in the flywheel aligned with the
on the crankshaft.
2«)- Rotate the flywheel clockwise
check to be sure the
has been turned
There is enough
has
set of points.
to prevent the
operat inz Slide the
with the
key
and
flywheel does not
contact any part of the magneto
wir mg,
21- Thread the flywheel
crankshaft and tighten it to the torque value
given in the Appendix.
22- Place the ratchet
top of the flvwheel and install
7/16" screws" On some model engines,
plate retainer covers
other model engines a very wide plate is
used with a definite
or the
nut onto the
for the starter on
the three
a
these screws. On
UP side and a DOWN
RATCHET