Evinrude 4906B 4HP 1969 Owner's Manual page 203

6-14 ELECTRICAL
ENGINE
GROUND
GROUND
TO LOWER
HOTOR COVER
it-amp or 20-amp fuse with a continuity
light, or install a new fuse and check the
charging circuit again with the engine oper-
ating. The it-amp and 20-amp fuses can
easily be "popped" out their retainers in the
panel of the junction box base and replaced
after the cover has been removed.
3-
Ground the
very QUICKLY and only
with a jumper wire while the
operating at approximately
MOMENTARILY grounding
voltage regulator is actually
the generator will "run wild".
meter registers a high reading
generator field is grounded, the circuit has a
broken wire, or the voltage
defective. If the amp meter
not change while the
grounded, then the indication
generator.
Voltage Regulator
1- Disconnect the positive lead from the
battery terminal an accidental short causing
damage in the circuit.
wingnuts on both sides of the junction box
cover. These wingnuts are "captive"
GENERATOR
field of the generator
MOMENTARILY
engine
2000 rpm.
the field,
bypassed and
If the amp
while the
regulator
reading does
generator field
is a faulty
Loosen the two
with
the cover and cannot be completely
ed, only released
(This arrangement
nuts). Disconnect
generator
junction box at the board, if the regulator is
to be re placed.
is
By
the
is
is
from the junction
prevents loss of the wing-
the wires between
and the terminal board in the
STARTER
SWITCH
remov-
box.
the