Evinrude 4906B 4HP 1969 Owner's Manual page 259

7-26 ACCESSORIES
SHIFT
pushing inward, and at the same time rotat-
ing the fitting 1/2-turn.
lock the fitting in the shift lever.
Throttle Cable End Installation
5- Install the throttle
over the casting guide.
into the small cylinder, and then slide the
cylinder down through the pin spring and
into the casting guide.
cylinder has a hole.
positioned vertically
align with the hole in the guide.
casing guide down over the throttle
and insert the end of the wire through the
sleeve. Tighten the top screw until a defi-
nite crimp is made in the wire.
LONG CABLE
CLAMP
NOT ADJUSTABLE
I
This action will
lock pin spring
Start the screws
Notice how the
This hole should be
with the casting to
Slide the
cable
TRUNNION
CRITICAL WORDS
Check the end of the cable to determine
if the temper has been removed.
has a bluish appearance,
at an earlier date and the temper removed.
The temper be removed to permit the
MUST
holding screw to make a crimp
to hold an adjustment.
tightened to this degree, the wire will slip
during operation and the adjustment
lost. If the wire has not been tempered,
heat the end, but not enough to melt the
wire. Bring the bottom
against the wire.
6- Install the trunion
engine, if necessary.
retainer with "P" stamped on the inside is
installed on the PORT
the retainer with the "S" installed
STARBOARD side.
cap to the trunion retainer.
plished by holding the trunion in a vertical
position; inserting it into the retainer;
then turning it to the horizontal position, as
shown.
7- Slide the guide over the pin onto the
engine, and then snap the retainer clip over
the end of the guide to lock it in place.
Cable Ad justm ents
See Chapter 8, Lower Unit, to properly
adjust the shift cable and to adjust
throttle cable.
If the end
it has been heated
in the wire
If the screw is not
will be
screw up tight
retainers to the
Check to be sure the
side of the engine and
on the
Connect the trunion
This is accom-
and
the