Evinrude 4906B 4HP 1969 Owner's Manual page 227

6-38 ELECTRICAL
is
against the brush
Therefore, a separate
required. With one brush attached
end cap and the other to the frame assem-
bly, positioning the brushes properly
the easiest task, but it can be done
patience.
Insert the negative brush into the retain-
er and push it in until the back part of the
spring rests on the side of the brush.
force secures the brush in the retainer in a
retracted position.
the frame assembly.
brush into the retainer
backward until the spring part of the retain-
er is on the side of the brush.
2- Work the cap over the end of the
armature shaft and the brushes over the
commutator. Just before the cap is com-
pletely into place against the frame, use a
punch and push on the back side of each
brush and the brush will snap in to ride
against the commutator.
then be behind the brush.
3- Align the end cap notch or mark with
the mark on the frame and the upper cap
mark with its matching mark.
Exploded
built into the re tainer •
is
brush spring
to the
is
This
Lower the end cap over
Install the positive
and push the brush
The spring will
Now, install
showing arrangement of major Autolite starter motor parts.
view
not
not
with
STARTER DR I VE
ASSEMBLY