Evinrude 4906B 4HP 1969 Owner's Manual page 130

7- Clean the surface of the intake mani-
fold thoroughly. Check to be sure all old
gasket material has been removed.
gasket over the studs and into place on
NEW
the manifold. Slide the carburetor
over the studs and secure it in place with
the two nuts. Tighten the nuts EVENLY and
ALTERNATELY. Connect the fuel line to
the carburetor. Connect the choke quick-
disconnect on the choke wire leading to the
dash. Install the starter
the engine being serviced is equipped with
these two units.
8- Connect the heat tube to the engine
and secure it in place with the compression
nut at each end.
9- Position the heat shield over the
heat tube and secure it in place with the
three attaching screws.
the adjustment portion of this section
operate the engine for testing and carbure-
tor adjustments under load.
Place a
down
and genera tor, if
Proceed directly to
to
TYPE II CARBURETOR 4-39