Evinrude 4906B 4HP 1969 Owner's Manual page 104

4-6 TYPE I CARBURETOR
REMOVAL AND DISASSEMBLING
1- On engines using an electric cranking
motor, remove the battery
battery terminals. Disconnect
from the engine or from the fuel tank at the
quick-disconnect fitting.
2- Remove the hood assembly from the
engine. Remove the choke and throttle
linkage to the carburetor.
3- Remove the fuel line from the car-
buretor. This may be accomplished by ei-
ther one of two methods:
ped with a self-contained
the fuel shut-off valve, located just below
the tank. Disconnect both ends,
remove the copper fuel line between
shut-off valve and the carburetor.
4- On engines utilizing a separate
tank, remove the tie-strap
ing the rubber hose connecting
connector to the carburetor.
leads from the
the fuel line
On engines equip-
fuel tank, close
and then
the
fuel
or clamp secur-
the fuel
Remove the
J/E
SHUTOFF
VALVE
rubber hose from the carburetor.
the nuts securing
crankcase. The carburetor
moved slightly forward as the nuts are loos-
ened in order to obtain clearance
nuts to clear the studs.
clear, lift the carburetor
manifold.
5- Remove and
from the intake manifold or the carburetor,
if the gasket adhered
when it was removed.
included in a carburetor repair kit.
CARBURETORS
FilTER
Remove
the carburetor to the
may have to
for the
After the nuts are
from the intake
DISCARD the gasket
to the carburetor
A new gasket is
4-13