Evinrude 4906B 4HP 1969 Owner's Manual page 344

6- Place the starter
on the engine and start
screws through the upper bearing
Check to be sure the guide is in place in the
bottom and top retainers.
bottom retainer screws.
Alternate Assembling Method
lA- If the lower bushing was removed,
install a bushing into the bottom collar
NEW
on the engine.
HELPFUL WORD
As an assist to installation,
bushing in hot water for about ten minutes,
and then lubricate
outboard
oil.
2A- Install the spring retainer
bottom side of the spool.
head and pinion gear down the spool shaft.
Align the holes and install
through the pinion gear and spool.
3A- Take the spring and lower it into
the bottom retainer.
into the retainer.
assembly in position
the two upper
support.
Tighten the two
first soak the
it with just a dorp of
from the
Slip the bearing
the roll pin
Hook the outer spring
PINION GEAR 5 & 6 HP 9-9