Evinrude 4906B 4HP 1969 Owner's Manual page 131

4-40 FUEL
ALL Electric Choke Installation
1- Install the rod extending
upper choke assembly to the lower hinge of
the choke. Secure the rod in place with a
cotter pin at each end.
2- Insert the choke assembly into the
cavity of the float bowl with the electrical
connector facing DOWNWARD
installation of the
electrical
is
carburetor installed.
clamp over the top of the choke to secure
the choke assembly in place.
3- Install the pin through the end of the
shaft of the choke solenoid and into the
lever attached to the carburetor.
washer and cotter pin.
4- Clean the surface of the intake mani-
fold thoroughly. Check to be sure all old
gasket material has been removed.
NEW gasket over the studs and into place on
from the
to permit
wires after the
Now, bring the
Install the
Place a
the manifold. Slide the carburetor
intake manifold studs and secure it in place
with the attaching nuts.
EVENL Y and ALTERNATELY.
fuel line to the carburetor.
electrical wires to the choke solenoid.
stall the starter motor and generator
engine being serviced is equipped with these
two units. proceed directly to the adjust-
ment portion of this section to operate the
engine for testing
ments under load.
onto the
Tighten the nuts
Connect the
Attach the
if the
and carburetor adjust-
In-