Evinrude 4906B 4HP 1969 Owner's Manual page 354

DISASSEMBLING
7- Remove the
gear, and the idler gear arm spring.
SAFETY WORDS
The next step could be dangerous.
moving the pulley from the cup
done with care to prevent personal injury.
8- Lift the pulley
use a screwdriver and work the spring free
of the pulley. DO NOT allow the spring to
be released from the cup.
has been removed, notice the position of the
spring loop. Remove
pulley. Notice how the rope unwinds from
t he pulley COUNTERCLOCKWISE.
9- Remove the bushings from the idler
gear arm. A bushing is installed
side of the pulley.
10- Two different
suggested to remove
starter cup. One method
continuously on the end of the spring that
contains the loop. The second method is to
simply toss the cup a safe
carpeting or a lawn, allowing the spring to
be released instantly from the cup.
If this second method is used, be sure the
spring will not cause a threat
ual in the area when it is released.
idler gear arm, idler
Re-
MUST be
SLIGHTLY and then
After the pulley
the rope from the
on each
methods are
the spring from the
involves pulling
distance onto
to any individ-
SWING ARM DRIVE GEAR 9-19