Evinrude 4906B 4HP 1969 Owner's Manual page 328

No. 308098. Press against the lettered
of the bearing. If the special tools are not
available, the race can be carefully worked
into place with a soft-headed mallet.
13- Install the
bearing race, using driver shaft guide plate
and bearing race installer, Tool No. 309033,
No. 309932, and No. 379247.
tapered front portion of the lower unit on a
block of wood and drive the race into the
housing. If the special tools are not avail-
able, the outside diameter of the lower unit
may be heated and the race tapped in with a
wooden block and mallet.
14- Install the cone-shaped
ing into the bearing
tapered end of the bear ing enters the race
first.
15-
Install the forward coil in the hous-
ing using special tool No. 379230. Feed the
coil wire into the groove in the bottom of
the housing. Use a dr iver shaft and guide
plate to install the coil properly.
16- The wire
covering. This covering must be located
behind the metal guard.
must fit alongside the housing.
Phillips screw in the bottom of the housing
with part of the metal tab protruding out of
front propeller shaft
Place
roller bear-
race Naturally,
ends have a plastic
The guard clamp
Install the
the square hole on top of the lower unit and
also with the wire coming out the hole.
17- Lower the forward gear, hub, and
spring assembly into the lower unit and over
the forward coil.
IS- Position the pinion gear into its re-
side
cess and resting against the forward gear.
the
the
ELECTROMATIC SHIFT 8-69