Evinrude 4906B 4HP 1969 Owner's Manual page 360

4- Lay the starter
surface. Remove the three screws securing
the pawl retainers
the three pawl springs, as shown.
illustration, two springs have already been
removed and the third is being removed.
5- Remove the three
retainers. Remove the center
the hub. Hold the pulley, and at the same
t irrie , lift the spindle and pin assembly, then
the equalizer cup, and friction spring, from
the pulley.
WARNING
The rewind spring is a potential hazard.
The spring is under tremendous tension when
it is wound -- a real tiger in a cage.
spring should accidently
personal injury could
struck by the spring with force.
the following step MUST be performed with
care to prevent personal injury to self and
others in the area.
accidently released at the wrong
action would be a BAD SCENE, a very BAD
SCENE, because serious
could result.
6- Lift the pulley straight
same time work the
on its back on a work
to the pulley. Remove
In the
pawls from their
screw from
If the
be released, severe
result from being
Therefore,
If the spring should be
t ime, such
personal injury
up and at the
spring free of the
ATOP FLYWHEEL WITH SPRINGS
pulley. The spring has a small loop hooked
into the pulley.
7- An alternate
hold the pulley and the housing together
tightly with the legs extending downward in
the normal direction.
plete assembly to the floor.
and safe method is to
Now, lower the com-
When the legs
9-25