Evinrude 4906B 4HP 1969 Owner's Manual page 370

A safe method
remove the hog rings
holds the spring. After the rings have been
removed, both persons work to unwrap the
spring, one coil at-a-time.
1- Slide the spring onto the outer
and then start the spring from the outside
edge of the housing and insert
housing COUNTERCLOCKWISE,
the accompanying illustration.
small hump in the
prevents the spring from being wound in the
wrong direction. Work the first
the housing, and then hold the spring down
with one hand and continue
spring into the housing.
are required to work the spring completely
into the housing. After the last portion is in
place, bend the end of the spring towards
the center of the housing.
allow the pulley pin to align with the loop in
the end of the spring, when the pulley is
installed.
2- Lower the pulley down over the top
of the spring with the pulley pin indexing
into the loop in the end of the spring.
accompanying illustration,
out for the boss on the
pulley. The pin is located directly
boss. The boss can, therefore,
during pulley installation.
3- Coat the spindle with a thin film of
OMC Type A lubricant.
washer onto the spindle.
4- Slide the friction
spindle with the flats in the washer indexed
with the flats on the spindle.
is for one person
while an assistant
it into the
as shown in
Notice the
housing. This hump
turn into
to wind the
Patience and time
This position will
In the
notice the call-
backside of the
under the
be a guide
Place the wavy
ring onto the
ATOP FLYWHEEL NO RETURN SPRINGS
to
pin
Housing (left) with the spring properly installed
the spring end bent toward the center.
pulley (right) must index into the loop on the spring end
during installation.
9-35
and
The pin in the