Evinrude 4906B 4HP 1969 Owner's Manual page 325

8-66 LOWER UNIT
Check the water
upper housing. Blow air through the screen
to dislodge any debris.
behind the screen.
Inspect the propeller for cracks, gouged,
bent, or broken blades.
worn, corroded, or damaged
can be removed with a file.
ALWAYS install
and seals during assembling and installation
to prevent leaks.
ASSEMBLING ELECTROMA TIC
Forward and Reverse Gear Assemblies
1- Insert the spacer,
the slot in the cupped end of the
gear in such a way that it encircles the gear
in the opposite direction
winding of the spring coils. Place the spring
in the gear with the spring key beside the
spacer key. Now, shift both keys to the side
of the slot against which they will pull.
2- Coat three NEW setscrews
tite TL-242, and install them in the forward
gear. Tighten the setscrews
a torque value of 30-35 In--lbs., beginning
with the one neaf,est the spring.
assembly in a 300 oven for 1/2 hour.
oven is not available, apply Locquic Primer
to the screws before tightening
"T"
and then allow them to cure for
3- The tolerance between the clutch hub
and the bushing is very close.
slide the gear-and-sprlng
hub.
New shift cable ready for installation.
cable with lubricant as an aid
pickup screen on the
Clean the area
Replace all bent,
parts. Burrs
NEW O-rings, gaskets,
with its key, into
FORWARD
to the normal
with Loc-
in rotation,
Bake the
If an
them,
hours.
lJ.
CAREFULLY
assembly onto the
Coat the
to
installation.
to