Evinrude 4906B 4HP 1969 Owner's Manual page 258

a
Attaching shift cable with adjustable trunnion
the shift arm, top, and connecting
with adjustable trunnion, bottom.
on the engine. The new cable and trunion
CANNOT be connected
tainer.
INST ALLA TION
Shift Cable End
1- Move the control lever at the shift
control box to the NEUTRAL position.
the gear shift fitting onto the control wire.
Check to be sure the
completely through the small holes in the
cable clamp. Clamp the anchor screws to
prevent twisting the cable.
the anchor screws
trunion on the gear shift cable.
2- Notice the flat and rounded areas of
the casting guide. The flat edge
TOWARD the engine.
is a flat area for the lever to ride during the
shifting action. After the cable is in place
TRUNNION
of
Proper installation
trunnion at the engine end.
the throttle cable
to the old-style re-
inner wire passes
The clamp and
MUST be parallel to the
MUST face
In this position, there
the throttle cable into the
Detailed draWing
in the casting guide, tighten the top screw
until a definite crimp is made in the cable.
If the screw is not tightened
inner wire will slip during operation and the
adjustment will be lost.
CRITICAL
Check the end of the cable to determine
if the temper has been removed.
to
has a bluish appearance,
at an earlier date and the temper removed.
The te mper MUST be re moved to permit the
holding screw to make a crimp
to hold an adjustment.
been tempered, heat the end, but not enough
to melt the wire. Bring the second screw up
tight against the wire.
3- Insert the shift cable control
cally into the trunion bracket
cable to a horizontal
by the arrows in the accompanying
Slide
tion.
4- Attach
shift lever on the engine by inserting
fitting into the shift control lever, and then
CABLE END FITTING
of
the shift trunnion
enough, the
WORDS
it has been heated
If the wire has not
and turn the
position, as indicated
the shift cable
LOCKING PLUG
7-25
at
the engine.
If the end
in the wire
verti-
illustra-
end to the
the
SCREW