Evinrude 4906B 4HP 1969 Owner's Manual page 371

9-36 HAND STARTERS
5- Install the nylon bushing onto the
spindle with the protrusions
indexed into the slots in the spindle.
the pin protruding from the bottom of the
spindle. This pin MUST drop into the hole in
the starter housing.
housing and visually locate this hole.
6- Lower the spindle
through pulley and index the pin into the
hole in the housing.
7- Place the washer inside the spindle
housing and then install the bolt through the
washer into the housing.
securely.
8- Install the three
retainers with the tip of each pawl laying
over the top of the nylon bushing.
9- Install the retainers
pawls to the pulley.
10- Turn the starter
retaining nut onto the thru-bolt
used). Tighten the nut securely.
sure the pulley will rotate
does not bind on the spindle.
on the bushing
Notice
Observe into the
assembly down
Tighten the bolt
pawls into their
securing the
over and install the
(if a nut is
Check to be
smoothly and
Rotate the