Evinrude 4906B 4HP 1969 Owner's Manual page 365

9-30 HAND STARTERS
After three complete turns have been made,
align the rope outlet in the pulley with the
outlet in the housing.
other suitable tool through the hole in the
pulley and the hole in the housing to hold
the pulley in the desired position.
the rope and feed the end through the pulley
and the housing and out the other side of the
housing. Pull the rope tight until the knot is
seated against the pulley.
9- A special tool is manufactured
OMC to install the handle onto the rope.
This tool has three prongs and is inserted
through the handle and then attached
rope and pulled back through the handle.
the special tool is not available take a stiff
piece of wire; insert it through the handle;
thread it through the rope; apply just a little
oil to the rope; then pull the wire and rope
through the handle.
10-
Work the end of the rope into the
handle anchor. Secure the rope in place by
pushing the anchor into the rubber handle.
11- Lightly pull on the rope to relieve
tension on the pin installed
Insert a drift pin or
Pick up
by
to the
If
through the
pulley and housing in Step 8. Maintain some
tension on the rope, remove the pin, and
allow the spring to SLOWLY wind the rope
onto the pulley. Check the bolt through the
spindle to be sure it is tight.
12- Lay the starter
the rope with quick movements,
same time check the pawls to be sure they
move towards the center
Release the rope slowly and check to be
sure the pawls return to their original posi-
tion under the retainers.
STARTER INSTALLATION
13- Position the starter
wheel with the three legs aligned over the
holes in the power head for the retaining
®
on its back and pull
and at the
of the pulley.
over the fly-