Evinrude 4906B 4HP 1969 Owner's Manual page 364

on the shoulder and the spindle installed
again. Rotate the pulley slightly
ERcLocKwIsE and then release
sure there is proper engagement
spr ing and the pulley
tension.
5- Install the three pawls onto the three
pins with the end of the pawls indexed in the
three cutouts of the equalizer cup. Connect
the three pawl springs to the equalizer cup.
6- Install the three
top of the pawls, and then secure them in
place with the retaining screws.
ROPE INSTALLATION
Rope Purchase Instructions
The length and diameter
rope required will vary depending on the
size horsepower engine
Therefore, check the Hand Starter
Specifications in the
purchase a quality nylon piece of the proper
length and diameter
proper rope, will you be assured of efficient
operation following installation.
Each end of the nylon rope should be
"fused" by burning them slightly with a very
small flame (a match flame will do) to melt
COUNT-
it to be
with the
has good spring
retainers over the
of the starter
being serviced.
Rope
Appendix, and then
size. Only with the
ATOP FLYWHEEL WITH SPRINGS
the fibers together.
have been "fused" and while they are still
hot, use a piece of cloth as protection
pull the end out flat to prevent
from forming.
7- Tie a figure 8 knot in one end of the
starter rope. Set the rope aside, by handy, to
be picked up with one hand.
8- Hold the housing with one hand and
rotate the pulley
COUNTERCLOCKWISE with the other hand.
After the end fibers
and
a "glob"
three complete turns
9-29