Evinrude 4906B 4HP 1969 Owner's Manual page 188

The No. 8 Location
10- Engines referenced
cation are to be adjusted
follower midway between the two marks on
the cam, at the moment the throttle
at the carburetor begins to move.
marks on the cam are about 1/4" apart.
11- Movement of the shaft can be exag-
gerated by attaching
wire to an alligator
teeth on one side of the clip; and then
attaching the clip to the throttle
shown. The wire jiggling will instantly indi-
cate movement of the shaft.
adjustment is accomplished
of two means, depending on the engine being
serviced. Check the Appendix for the ad-
justment to be performed.
numbers are listed in the Appendix under
Primary Pickup Adjustm ent Note.
to the No.8
with the cam
shaft
The
a short piece of stiff
clip; grinding down the
shaft, as
The actual
by ONLY ONE
The reference
12-
Per Note 1 in the Appendix, loosen
lo-
the two screws under the armature
and move the primary pickup inward or out-
ward to meet the follower.
13- Per Note 4 in the Appendix, loosen
the clamp on the throttle
the roller to meet the armature cam.
SYNCHRONIZATION
shaft and move
5-29
plate