Evinrude 4906B 4HP 1969 Owner's Manual page 353

9-18 HAND STARTERS
2- Remove the knot tied in the rope in
Step 1. Allow the rope to
into the starter. Before the rope end passes
the cowling, firmly grasp the starter pulley,
and then allow the starter to unwind.
3- Observe the back side of the starter.
Notice the hook of the
protruding out of a
Grasp the spring hook with a pair of needle-
nose pliers, and then pull the spring out as
far as possible, to relieve
spring.
4- Remove the 3/8" bolt from the brac-
ket between the starter
housing.
SLOWLY wind
starter spring
hole in the starter.
tension on the
and the exhaust
5- Hold the starter
hand, and at the same time
large bolt from the center of the starter.
DO NOT remove this bolt at this
Remove the starter from the engine.
6- If the starter is only removed in order
to accomplish other work, install a 3/8" x 16
nut onto the far side of the thru-bolt to hold
the starter together
from escaping.
together with one
LOOSEN
time.
and prevent the spring
the