Evinrude 4906B 4HP 1969 Owner's Manual page 215

6-26 ELECTRICAL
b- If voltage is present-at No.6, connect
a voltmeter at No.3 and to No.7.
one end of a jumper wire to No.2,
positive terminal of the battery
MENTARIL Y make contact with the other
end at No.6, the
voltage is indicated through the starter sol-
enoid, the solenoid is satisfactory
problem has been corrected
the tests. Sometimes,
electrical circuits,
been taken almost accidently, a bad connec-
tion has been made good, etc.
noid test falled, it does not necessarily
mean the solenoid is defective.
noid may not be properly grounded through
the cutout switch.
switch may be defective
checked as outlined later in this section.
c- With the voltmeter still connected at
No. 3 and No.7, connect one end of a jump-
er wire at No.8, the starter
the other lead to a good ground.
second jumper wire at No.2, the positive
terminal of the battery,
starter solenoid. The voltmeter should indi-
cate voltage is present.
Connect
the
and MO-
starter solenoid.
and the
while making
when working with
corrective action has
If the sole-
The sole-
Therefore, the cutout
and should be
solenoid, and
Connect a
to No.6, the
If voltage is not
present, the starter
and MUST be replaced.
Testing Throttle Advance Cut-out Switch
a- Remove the existing wire from No. 1
If the switch terminal.
lead of a ohmm eter to the terminal.
nect the other test probe lead to a good
ground. Depress the switch button and the
ohmmeter
continuity
defective and MUST be replaced.
the heavy cable at No.5, the starter motor.
6-12 STARTER DRIVE GEAR SERVICE
STARTER
Before beginning any work on the starter
motor, disconnect the positive
the battery
Disconnect
motor terminal.
Remove the 1/2" bolt securing the star-
ter bracket.
starboard side of the engine just above the
solenoid is defective
Connect
should indicate continuity.
is not indicated, the switch is
REMOVAL
terminal. Remove the hood.
the red cable at the starter
This bolt is located
one probe
Con-
If
Connect
lead from
(+)
on the