Evinrude 4906B 4HP 1969 Owner's Manual page 186

The No.5 Location
1- The pickup location
location is PORT side of the mark.
means that the pickup on the carburetor
arm should be just to the
mark on the cam. To obtain this position,
the cam, or the cam follower,
adjusted until pickup is at the proper loca-
tion and the throttle
move.
2- Movement of the shaft can be exag-
gerated by attaching
wire to an alligator dip; grinding down the
teeth on one side of the clip; and then
attaching the dip to the throttle
for the No.5
This
PORT side of the
is to be
shaft just begins to
a short piece of stiff
shaft, as
SYNCHRONIZATION
shown. The wire jiggling will instantly in-
dicate movement of the shaft.
adjustment is accomplished
method, depending on the engine being ser-
viced. Check the Appendix for the ad-
justment to be performed.
numbers are listed in the Appendix under
Primary Pickup Adjustment Note.
3- Per Note 1 in the Appendix, loosen
the two screws under the armature
and move the primary pickup inward or out-
ward to meet the follower.
The No. 6 Location
4- Engines referenced
to the No.6 Primary Pickup Location are to
be adusted to the STARBOARD
mark. To obtain this position, the cam, or
the cam follower, (depending the type of
engine being serviced),
until pickup is at the proper location and the
throttle shaft just begins to move.
ment of the shaft can be exaggerated
attaching a short piece of stiff wire to an
alligator dip; grinding down the teeth on
5-27
The actual
by ONLY ONE
The reference
plate
in the Appendix
side of the
is to be adjusted
Move-
by