Evinrude 4906B 4HP 1969 Owner's Manual page 228

the thru-bol ts through
frame, and thread them into the upper cap.
4- Slide the rubber spacer or collar into
the starter bracket,
the starter bracket over the starter motor.
Install the thru-bolts
the frame, and thread them into the starter
bracket. Tighten the thru-bolts securely.
To test the complete starter motor, pro-
ceed directly to Section 6-16.
To install the starter
engine, proceed directly to Section 6-17.
the end cap, the
if used. Now, install
through the end cap,
motor onto the
6-15 PRESTOLITE SERVICE
REMOVAL
1- Before
starter motor, disconnect the positive
lead from the battery
the engine hood.
at the starter
1/2" bolt securing the starter bracket.
bolt is located on the starboard side of the
engine just above the carburetor.
the three 7/16" bolts (or nuts in some cases)
securing the starter
engine. Remove the starter
bracket together.
-
GOOD NEWS
If the only motor repair necessary
replacement
does not have to be removed.
motors have thru-bolts
and lower cap to the field frame assembly.
In all cases both caps have some type of
mark or boss.
properly align the caps with the field frame
assembly.
PRESTOLITE STARTER
beginning any work on the
terminal.
Disconnect the red cable
motor terminal. Remove the
motor bracket
motor and
of the brushes, the drive gear
All starter
securing the upper
These marks are used to
6-39
(+)
Remove
This
Remove
to the
is