Evinrude 4906B 4HP 1969 Owner's Manual page 336

9-1 INTRODUCTION
Three different type hand starters
be installed on the Johnson/Evinrude
board engines covered in this manual.
type starter may have two, and sometimes
three, models.
All
chapter with detailed
illustrations.
Type I
The first type is a cylinder with a pinion
gear arr angern ent similar to an automotive
starter motor. The unit is mounted on the
side of t he engine in a vertical
the starter rope is pulled, a nylon drive gear
on
Starter installation
This starter is similar in operation
type starter.
HAND STARTER
may
out-
Each
will be covered in this
procedures and
position. As
5 and 6
the hp hp engines.
to an
automotive
9
slides upward and engages the flywheel ring
gear. Once the engine starts the drive gear
automatically disengages.
dures for both models of this starter
presented in Sections
Type II
One model of this type starter
found on the outboards
ual. The starter
port side of the engine and the drive gear
works on an axis and enga.ges the flywheel
directly. As the rope is pulled, a swing
Starter installation
difference with the unit in the left column, this page.
Service
9-2 and 9-3.
will be
covered in this man-
assembly is mounted on the
on
all 9.5 hp engines. Notice the
proce-
are