Evinrude 4906B 4HP 1969 Owner's Manual page 367

9-32 HAND STARTERS
STARTER REMOVAL
1- Disconnect
any linkage between
starter and the carburetor.
age out of the way.
leg retaining screws, and then lift the com-
plete starter from the engine.
2- Pull the rope out far enough, and then
tie a knot in the rope.
rewind to the knot.
out of the rubber covered handle, then re-
move the rope from the anchor.
the handle from the rope.
the rope, and then hold the disc pulley, but
the
Move the link-
Remove the starter
Allow the rope to
Work the rope anchor
Remove
Untie the knot in
permit it to turn and thus allow the rope to
wind back onto the pulley SLOWLY.
ue to allow the spring in the pulley
unwind SLOWLY until all tension has been
released.
3- Remove the center bolt nut from the
top side of the starter.
have a center bolt nut.
the nut may have vibrated loose, but if the
center bolt has threads showing, a nut
be installed during assembling.
4- Lay the starter
surface. Remove the three screws securing
the pawl retainers to the pulley.
5- Remove the three
retainers.
6- Remove the center
hub.
7- Hold the pulley,
time,
remove the spindle, the wavy washer,
friction ring, and the nylon bushing from the
center of the pulley.
Contin-
to
Some models do not
On other models,
MUST
on its back on a work
pawls from their
screw from the
and at the same