Evinrude 4906B 4HP 1969 Owner's Manual page 243

7-10 ACCESSORIES
I
the wire. Momentarily
off to rotate the wire and at the same time
allow lubricant to flow into the cable,
shown.
ASSEMBLING
Throttle Cable into Shift Box
1- If the slider sleeve was removed from
the throttle lever, install
the throttle lever with the hole on the end
for securing the throttle
site end of the hole that accommodates
cable. Position the center
with the center of the throttle
the square nylon plug with the holes in the
plug in a vertical
cable to slide through.
screws, or possibly Allen screws, are usee! on
each end of the sleeve.
screw into the bottom
prevent the sleeve from rubbing on the shift
box. Install the longer screw on the top part
of the sleeve. Install the sleeve
hole in the sleeve aligned with the hole for
the cable.
CRITICAL WORDS
, Check the end of the cable to determine
if the temper has been removed.
INSERT PULLED OUT
turn the drill on and
the ratchet into
cable on the oppo-
of the ratchet
lever. Install
position to perrnit the
Two different size
Install the short
of the sleeve
with the
If the end
CASING GUIDE
has a bluish appearance,
at an earlier
The temper MUST be removed to permit the
holding screw to make a crimp in the wire
to hold an adjustment.
been tempered,
to mel t the wire.
2- Slide
\Vork the inner wire into the sleeve and out
the end of the ratchet.
until the end is flush with the ratchet
face. Tighten the TOP holding screw enough
to make a definite
shown. If this screw
make the crimp,
operation and the adjustment
After the top screw has been fully tighten-
ed, bring the other screw up tight against
the reo It is not necessary
wi
as screw to make a crimp in the wire.
3- Work the throttle
over the friction
same time feed the throttle
in the box half. Check to be sure one of the
small caps
trunnion. Install the washer and the screw
with the concave side of the washer on the
same side as the screw.
securely.
the
top of the trunnion.
lever for ease of movement
binding.
to
it has been heated
date and the temper
If the wire has net
heat the end, but not enough
the cable into the
Push the wire back
crimp in the wire,
is not tightened
the wire will sllo during
for this second
lever handle down
nylon block and at the
cable into place
is on the bottom
Tighten the screw
Install the other trunnion
Check
with no sign of
removed.
ratchet.
sur-
as
to
will be lost.
side of the
cap on
the throttle