The Armature - Evinrude 4906B 4HP 1969 Owner's Manual

16- To install the new seal:
inside diameter of the seal with a thin layer
of oil. Apply OMC sealer
diameter of the seal.
the crankshaft and start it into the recess of
the powerhead. Use the special
work the seal completely
recess.
17- Install the Woodruff key into the
crankshaft. On some models, a pin was used
to locate the cam for the points.
was used, install it at this time.
difference to the sides of the cam.
almost all cams, the word TOP is stamped
on one side. Also, on some cams, the groove
does not go all the way through.
it is very difficult to install the cam incor-
rectly, with the wrong side up.
Coat the
to the outside
Slide the seal down
tool and
into place in the
If the pin
Oberve the
On
Therefore,
Slide the cam down the crankshaft
the word TOP facing
working the cam down the crankshaft
it is in place over the Woodruff key, or pin.
If the coil is not to be removed, proceed
directly to Step 25.
perform the procedures
section.
Coil Removal from the Armature Plate

The armature

plate must be removed as
described earlier in this section, Step 12 and
Step 13. Notice how the coil has a laminat-
ed core. The coil cannot be separated,
is, the laminations from the core.
18- Turn the armature
notice how the high-tension leads are instal-
led on the plate in a recess.
the wires is misleading.
No.1 spark plug is NOT connected
No.1 coil as might be expected.
19- Remove the three screws attaching
the coils to the armature
SERVICING 5-17
with
upward. Continue
until
To remove the coil,
in the following
that
plate over and
The routing of
The wire to the
to the
plate.