Evinrude 4906B 4HP 1969 Owner's Manual page 223

6-34 ELECTRICAL
the brushes make contact with the commu-
tator. Now, remove
Align the mark on the upper cap with the
matching mark on the field frame.
3- Place the washer onto the commuta-
tor shaft, then place the cap onto the end of
the field frame assembly.
on the lower cap with the mark on the field
frame.
4- Slide the rubber spacer or collar into
the starter bracket,
the starter bracket over the starter
Install the thru-bolts
the match sticks.
Align the mark
if used. Now, install
motor.
through the end cap,
the frame, and thread them into the starter
bracket. Tighten the thru-bolts securely.
To test the complete starter
ceed directly to Section 6-16.
To install the starter
engine, proceed directly to Section 6-17.
6-14 AUTOLITE STARTER
MOTOR SERVICE
REMOVAL
1- Before beginning any work on the
starter motor, disconnect
lead from the battery
the engine hood. Disconnect the red cable
at the starter motor terminal.
1/2" bolt securing the starter
bolt is located on the starboard side of the
engine just above the carburetor.
the three 7/16" bolts (or nuts in some cases)
securing the starter
engine. Remove
bracket together.
GOOD NEWS
If the only motor
replacement of the brushes, the drive gear
does not have to be removed.
motors have thru-bol ts securing the upper
and lower cap to the field frame assembly.
In all cases both caps have some type of
mark or boss. These marks are used to
properly align the caps with the field frame
assembly.
motor, pro-
motor onto the
the positive
terminal. Remove
Remove the
bracket.
Remove
motor bracket to the
the starter motor
repair necessary
All starter
(+)
This
and
is