Evinrude 4906B 4HP 1969 Owner's Manual page 363

9-28 HAND STARTERS
A spring properly installed and seated on the spindle
shoulder.
3- Slide the equalizer
spindle. Work the spring around the outside
diameter of the spindle.
assembly down through the pulley and index
the pin into the hole in the housing.
tempt to rotate the large pulley. The pulley
should turn freely if the spindle has been
installed properly.
the spindle housing and then install the bolt
through the washer
Tighten the bolt securely.
Housing (left) with the spring properly installed
the spring end bent toward the center.
pulley (right) must index into the loop on the spring end
during installation.
cup onto
Lower the spindle
A
Place the washer inside
into the housing.
The pin in the
the
t-
4- Turn the starter
retaining nut onto the thru-bolt
used). Tighten the nut securely. Check to
be sure the pulley will rotate smoothly and
does not bind on the spindle.
on the spindle was allowed to slip out of
place on the shoulder, then the spindle must
be removed, the spring properly positioned
and
over and install the
(if a nut is
If the spring