Evinrude 4906B 4HP 1969 Owner's Manual page 381

9-46 HAND STARTERS
the rope into the handle anchor.
rope in place by pushing the anchor into the
rubber handle.
8- Pull on the rope enough to untie the
knot, and then allow the rope to slowly
recoil into the pulley.
9- Lay the starter
pulley facing toward you.
print on the pulley:
RECOILED. Also notice the arrow on the
housing. On Johnson engines, when the rope
is fully coiled (the starter
wound) the arrow must fall between
marks on the pulley.
pulley you will notice
Evinrude), On the Evinrude engines, the
arrow must fall between the two marks on
the pulley. If the arrow
aligned the starter rope is not the proper
length. It is either too long or too short.
The arrow must align properly for the start-
er to be timed with the engine.
beginning of this section.
10-
With the starter
pull the rope with quick movements,
the same time check the pawl to be sure it
moves toward the
Release the rope slowly and check to be
sure the pawl returns to its original position.
STARTER INSTALLATION
11- Position the starter
wheel with the three legs aligned over the
holes in the powerhead
bolts. Install the retaining bolts and tighten
them securely.
Secure the
on its back with the
Notice the im-
ARROW HERE ROPE-
pulley completely
the
Further up on the
the letter E (for
is not properly
See the
still on its back,
and at
center of the pulley.
over the fly-
for the retaining