Evinrude 4906B 4HP 1969 Owner's Manual page 116

ALL ELECTRIC CHOKE - REMOVAL
The electric choke is mounted on the
bottom side of the carburetor.
1- Disconnect the electrical
the choke solenoid. Disconnect the fuel line
from the carburetor.
securing the carburetor
fold. Lift the choke from the
Scribe a mark on the side of the bracket to
ensure the choke solenoid will be installed in
its orginal position.
2- Remove the cotter key, washers, and
pin from the choke plunger and pin.
3- Remove the two screws securing the
clamp to the carburetor.
solenoid from the carburetor.
solenoid CANNOT be serviced.
should be in good condition.
re moved by sliding it off the solenoid.
serve the two washers and spring under the
boot. Take care not to lose these three
items. Clean the solenoid, and then slide
the boot back in place.
ready to be installed.
4- Remove the cotter
end of the rod extending from the upper
section to the lower section of the carbure-
tor, and remove the rod. This rod works the
choke in the upper body of the carburetor
when the electric choke is activated.
ther disassembly of the all electric choke is
wire from
Remove the two nuts
to the intake mani-
engine.
Remove the choke
The choke
The boot
It may be
Ob-
The solenoid is then
pins from each
Fur-
ALL ELECTRIC CHOKE 4-25