Evinrude 4906B 4HP 1969 Owner's Manual page 289

8-30 LOWER UNIT
Two shift lever screws.
to
ground assist installation,
10- Place a NEW seal in the lower cap
and hold the seal in the groove with sealer.
Apply a small amount of silicone sealer on
each side of the bearing
This sealer will form a complete seal when
the lower unit cap is installed.
GOOD WORD
If time is taken to grind the end of the
screw to a SHORT point, it will make the
task of installation
and shift lever are not aligned exactly,
screw will "seek" and make the alignment as
it passes through. However, do not make a
long point or the screw will not have enough
support and would bend during operation
the shift lever.
11- Position the lower unit cap over the
gear assembly onto the lower unit housing.
If the unit being serviced uses a shift lever
pin, work the cap until the pin indexes into
the recess of the cap.
12- Apply a drop of sealer into the open-
ing for each cap retaining screw to ensure a
complete seal between
lower unit housing. Install the screws secur-
ing the cap to the
Tighten the screws
EVENLY.
The right screw has been
as
explained in the text.
gear case head.
much easier. If the cap
the cap and the
lower unit housing.
ALTERNATELY
the
of
and
®
®