Evinrude 4906B 4HP 1969 Owner's Manual page 156

16- Install the fuel cap and chain. If the
chain and cap were removed,
cotter pin through the flange in the tank to
secure the chain in place.
17- Install the fuel cap.
was removed, attach
with the retaining screw.
18- After the work is completed,
quantity of fuel/oil mixture to the tank and
test the system for proper operation and no
leaks. Insert a small screwdriver
end of the fuel connector
line to open the check valve.
fuel tank pump and and be prepared to catch
fuel being discharged
hose.
Fuel Line
Service
The only service
on the fuel lines is replacement
rings in the fuel line connectors,
placement of the hoses.
fuel lines are available
dealer.
19- Use two ice picks or similar
and push down the center
connector and work the O-ring out of the
hole. Repeat the procedure
O-ring from the other check valve.
use a
NEW
If only the cap
the chain to the cap
add a
into the
at the end of the
Operate the
from the end of the
work to be performed
of the
and re-
New O-rings and
at the local OMC
tool,
plunger of the
to remove the
FUEL TANK AND LINE
20- Apply just a drop of oil into the hole
of the connector.
oil to the surface of the O-r ing. Pinch the
O-ring together
while simultaneously
press the plunger inside the connector.
0-
Apply a thin coating of
and work it into the hole
using a punch to de-
4-65