Evinrude 4906B 4HP 1969 Owner's Manual page 181

5-22 IGNITION
Point Set
10-
Install the condensers
them in place with their hold-down screws.
11- Hold the base side of the points and
slide it down over the anchor pin onto the
armature plate. Install the wavy washer and
hold-down screw to secure the point base to
the armature plate.
screw securely.
12-
Hold the moveable arm and slide the
points down over post, and at the same
time, hold back on the points and work the
spring arm to the inside of the post of the
base points. Continue to work the points on
down into the base.
13- Observe the
should be together and the spring part of the
moveable arm on the inside of the flat post.
14- Install the flat retainer onto the flat
bar of the base points. Check to be sure the
flat spring from the other side of the points
is on the inside of the retainer.
retainer inward until the indentation
into the hole in the base.
MUST be horizontal
plate.
15-
Install the wire clip into the groove
of the post.
Repeat Steps No. 10 thru
second set of points.
and secure
Tighten the hold-down
points. The points
Push the
slips
The re tz.iner
with the armature
15 for the