Evinrude 4906B 4HP 1969 Owner's Manual page 379

9-44 HAND STARTERS
with one hand and continue
spring into the housing.
are required to work the spring completely
into the housing. After the last portion is in
place, bend the end of the spring towards
the center of the housing.
allow the pulley pin to align with the loop in
the end of the spring, when the pulley is
installed.
Alternate Method
An al ternate method of installing a NEW
spring into the housing with less risk of
personal injury is presented
nying illustrations.
lA- Remove ONLY the hog ring next to
the end of the outside wrap of the spring.
2A-
Pull on the outside end of the spring.
As the spring is pulled, the inside diameter
will get smaller and smaller,
When the diameter is a bit smaller than the
inside diameter of the starter
the entire free end of the spring around the
coiled portion.
3A- CAREFULL Y
spring into the starter
on the free end of the spring indexed over
the peg in the housing and the spring feeding
COUNTERCLOCKWISE,
the second hog ring WITHOUT allowing the
spring to escape from the housing.
and safe method is to cut the hog ring with
a pair of "dikes". Bend the inside end of the
spring toward the center of the housing to
permit the pin in the pulley to index into the
loop.
to wind the
Patience and time
This position will
with accompa-
as shown.
housing, wrap
lower the coiled
housing with the loop
as shown. Remove
An easy
3- Lower the pulley down over the top
of the spring with the pulley pin indexing
into the loop in the end of the spring.
accompanying illustration,
out for the boss on the backside
pulley. The pin is located directly under the
boss. The boss can, therefore,
during pulley installation.
4- Lower the spindle
through pulley. Place the washer and lock-
washer inside the spindle housing and then
install the bolt through the washer into the
housing. Tighten the bolt securely.
2A
In the
notice the call-
of the
be a guide
assembly down
Check