Evinrude 4906B 4HP 1969 Owner's Manual page 251

7-18 ACCESSORIES
from 33" to 42") on the cable from the shift
box. BE SURE there
cable, and then secure the clamp to the boat
at the measured position.
Next, place the warm-up
slow position and observe
slack in the cable between the shift box and
the first clamp. The slack should not be
more than 1/2 Inch.
in the cable. The radius of any bend
not be less than 5".
ALWAYS use the correct length of cable
when replacing the assembly.
9- Adjusting Starter Lockout Switch
Move the shift lever to the
position and the warm-up
START position. Now, turn
ADVANCE
is no slack in the
lever in the
the amount
AVOID SHARP TURNS
MUST
NEUTRAL
lever to the
the ignition
NO SLACK
switch to the START
to crank the engine.
crank the engine, move the warm-up lever
to the IDLE
setscrew counterclockwise
Move the auxiliary throttle
position, and then turn the ignition switch to
the START
still fails
warm-up lever in the full
tion, back off the warm-up lever to deter-
mine the point at which the starter
to operate.
setscrew clockwise
until the starter
warm-up lever in the full
7-6 PUSHBUTTON
EVINRUDE
GOOD WORDS
A friction screw is installed
tom side of the shift box. This screw allows
friction adjustment
This arrangement
dle from "creeping" after
leases his grip on the handle.
screw on the front of the box permits ad-
justment of the throttle
of
movement
and subsequent shutdown of the engine.
adequate adjustment
shift box, and the the engine continues
position in an attempt
If the starter
position, and then rotate the
one-half
to the
position again. If the starter
to crank the engine
ADVANCE
Make the adjustment
a half-turn
operates only with the
START
SHIFT BOX SERVICE
UNITS ONL Y
of the throttle
prevents the throttle
the operator
handle to prevent
past a satisfactory idle position
cannot be made at the
fails to
turn.
START
with the
posi-
ceases
of the
at a time
position.
in the bot-
handle.
han-
re-
A thumb-
If
to