Evinrude 4906B 4HP 1969 Owner's Manual page 340

and at the same time
from under the pinion gear.
starter rope to rewind in a normal manner.
After the rope is fully
starter spool, the rope handle should be up
tight against the engine
handle is not up tight, the rope was installed
to long or the starter
should be replaced.
STARTER REMOVAL
AUTHOR'S NOTE
For photographic
anying pictures were taken servicing
ter from a powerhead
exhaust housing. The hood need only be
removed to work on the starter.
1- Pull approximately
rope out, and then form a knot in the rope
to prevent it from recoiling.
to recoil until the knot is tight against the
cowling. Remove the rope handle.
remove the pliers
Allow the
wound onto the
cowling. If the
spring is weak and
clarity, the accomp-
a star-
removed from the
3/l~ of the starter
Allow the rope
PINION GEAR 5 & 6 HP 9-5