Evinrude 4906B 4HP 1969 Owner's Manual page 139

4-48 FUEL
Any damage to the orifice will result fuel
leakage and poor engine performance.
2- Install the drain plug with a
gasket and tighten it securely with a 7/16"
wrench.
3- Install the inlet needle seat and gas-
ket. TAKE CARE to use the proper size
screwdriver to install the seat.
diameter of the seat is damaged the needle
valve will leak fuel causing a flooding condi-
tion in the carburetor.
4- Apply just a drop of oil into the seat,
and then insert the inlet needle into seat.
5- Position a NEW float over the needle,
and then slide a NEW hinge pin into place.
6- Hold the carburetor
sition (up-and-down), and observe the float.
MUST be parallel
The float
with the surface of the carburetor
the float is not parallel
the float ever so slightly, as shown, until the
correct positioning is obtained.
7- Slide the float bowl gasket over the
float and nozzle into position on the carbu-
retor base.
NEW
If the inside
in a vertical po-
(align evenly),
body. If
CAREFULLY bend
(j)