Evinrude 4906B 4HP 1969 Owner's Manual page 288

O-RING
An assembled bearing head without
This bearing has a protrusion
cutout in the lower unit housing.
in the forward gear bearing. Also notice the
protrusion on the end of gearcase
This protrusion
MUST
the housing when
assembly is installed.
may have a hole.
lower unit housing indexes with the hole
during installation.
5- Check to be sure the
properly located. Check to be sure the shift
rod is clean and smooth (free of any burrs or
corrosion). Coat the shift rod and the
ring with oil as an aid to installation.
the shift rod down through the O-ring and
bushing into the gear case.
6- Slide the propeller shaft assembly in-
to the lower unit housing. Check to be sure
the slot in the forward gear bearing indexes
with the pin in the lower unit, and the
protrusion on the end of the gear case head
indexes in the slot in the housing. On some
models, a pin in the lower unit housing
MUST index with a hole in the gearcase
head.
7- Lubricate the cradle, and then slip it
into the dutch dog groove.
S- Bring the shift lever down over the
cradle and snap the fingers of the lever into
the index hole.
which indexes with
head.
index with the slot in
the propeller shaft
Some gearcase units
A pin imbedded in the
piruon gear is
Slide
MANUAL SHIFT 5 HP TP 25 HP
a
the cradle.
is in the NEUTRAL position. Push or pull on
the shift rod to move it up or down until the
dutch dog is in the center
forward and reverse gears.
the pin-type holding mechanism, install the
pin into the lever.
9- Lay down a bead of No. 1000 Sealer
into the groove of the cap in preparation
installing the seal.
0-
Check to be sure the dutch dog
between
If the lever uses
8-29
the
to