Evinrude 4906B 4HP 1969 Owner's Manual page 205

6-16 ELECTRICAL
GENERATOR SERVICE
Disconnect the positive Iead at the
1-
battery terminal. Remove the hood from
the engine. If the engine has a hand starter,
remove the retaining bolts and lift off the
hand starter. Prevent the shaft from turn-
ing by engaging an open-end
the flats on the generator
t he pulley. Now, while continuing to hold
the wrench on the shaft,
from the top of the generator
move the cover from
generator pulley.
wrench with
shaft underneath
remove the nut
pulley. Re-
the inside of the
2- Remove the generator
pulley. Use a screwdriver
tool and pry the puller up and free of the
generator shaft. Hold the generator,
the same time remove the nuts from the top
of the generator support bracket,
generator is free.
SPECIAL WORDS
In some cases,
remove the 7/16" bolts securing the bracket
to the engine, and then
bracket and generator
ket is then removed from the generator.
3- Remove the two wires on the bottom
side of the genera tor.
generator stud is smaller than the other and
the electrical connectors are different
to match the studs.
4- Remove the two nuts from the wire
terminals at the bottom of the generator.
Work out the two white
around the studs. Remove the two thru-
bolts.
ARMATURE
TERMINAL
belt from the
or other similar
and at
and the
it is just as easy to
to remove the
together. The brac-
Notice how one
sizes
insulators from
CD