Evinrude 4906B 4HP 1969 Owner's Manual page 244

Shift Cable into Shift Box
4- If the slider sleeve was removed from
the shift lever, install the slide rack into the
shift lever with the hole on the end for
securing the shift cable on the opposite end
of the hole that will accommodate
ble. Position the center of the slide with
the center of the shift lever.
~quare n~lon plu& ~ith the holes in the plug
In a ver tical pOSItIOnto permit the cable to
slide through. Two different size screws are
used on each end of the sleeve.
short screw into the bottom of the sleeve to
prevent the sleeve from rubbing on the shift
box. Install the longer screw on the top part
of the sleeve.
hole in the sleeve aligned with the hole for
the cable.
CRITICAL
if the temper has been removed.
has a bluish appearance,
at an earlier date and the temper removed.
The temper MUST be removed to permit the
holding screw to make a crimp in the wire
to hold an adjustment.
been tempered, heat the end, but not enough
to melt the wire.
inner wire into the sleeve and out the end of
the rack.
is flush with the rack surface.
TOP holding screw enough to make a defi-
nite crimp in the wire, as shown.
screw is not tightened
the wire will slip during operation and the
the ca-
adjustment will be lost. After the top screw
has been fully tightened,
Install the
screw up tight against the wire.
necessary for this second screw to make a
crimp in the wire.
washer into the shift box, and then work the
shift lever handle down into the shift box
with one of the small caps under the shift
NEW SHIFT LEVER
Install the sleeve with the
WORDS
Check the end of the cable to determine
Slide the cable into the rack.
Push the wire back until the end
5- Place the wavy washer and regular
7-1 ,
Install the
If the end
it has been heated
If the wire has not
Work the
Tighten the
If this
to make the crimp,
bring the other
It is not