Evinrude 4906B 4HP 1969 Owner's Manual page 173

5-14 IGNITION
that are used to secure the ratchet
removed in Step 2. NEVER attempt
puller which pulls on the outside edge of the
flywheel or the flywheel may be damaged.
After the puller is installed,
center screw onto the end of the crankshaft.
Continue tightening the screw until the fly-
wheel is released from the crankshaft.
move the flywheel.
ler center bolt with a hammer in an attempt
to dislodge the flywheel.
ser iously damage the lower seal and/or low-
er bearing.
5- STOP, and carefully observe the mag-
neto and associated
how the magneto is assembled.
to make notes on the wire routing.
how the heels of the laminated
the coil attached, is flush with the boss on
the armature plate.
replaced in their proper positions.
elect to follow the practice of many profes-
sional mechanics by taking a ser ies of pho-
tographs of the engine with the flywheel
removed: one from the top, and a couple
from the sides showing the wiring and ar-
rangement of parts.
Breaker Points/Condenser Service
The armature plate does not have to be
removed to service the magneto.
necessary to remove
This particular engine differs
dures because a washer is installed
nut.
plate
to use a
tighten the
Re-
DO NOT strike the pul-
Such action could
wiring layout. Study
TAKE TIME
Observe
core, with
These items must be
You may
If it is
the plate for other
from the text proce-
under the flywheel
service work, such as to replace the coil or
to replace the top seal, see Step 7.
For simplicity and clarity, the following
procedures and accompanying
cover a one-cylinder
larger than one-cylinder
repeat the procedures
breaker point assembly.
6- Remove the
wires from the coil and condenser to one set
of points. On engines equipped with a key
switch, "kill" button, or "run-a-way"
a ground wire is also connected
screw.
7- Using a pair of needle-nose
remove the wire clip from the post protrud-
ing through the center of the points.
8- Again, with the needle-nose
remove the flat retainer
points together.
Plate installed on some engines covering
tion hole in the flywheel.
to
indicate which side is
tion.
illustrations
ignition system.
is being serviced,
for each coil and
screw attaching
switch,
to this
pliers
pliers,
holding the set of
the inspec-
The plate is clearly marked
to
face upward during installa-
If
the