Evinrude 4906B 4HP 1969 Owner's Manual page 250

4- AL WAYS TAKE
sembling the shift box, not to damage .the
remote-control unit.
MUST lay in the cut-out
throttle cam.
5- Carefully work the two halves of the
box together with the cam lever fitting into
the recess of the throttle
throttle link fitting into the warm-up lever.
6- Secure the two halves together
the screws into the side of the box.
the shift box to the side of the boat with the
attaching hardware.
nuts SHOULD ALWAYS BE USED because a
loose shift box during high speed operation
could be extremely dangerous.
shift wire under the dash.
CARE when as-
The arm on the switch
portion of the
handle and the
with
Secure
Bolts with self-locking
Connect the
SINGLE LEVER SHIFT BOX
7- The tension of the throttle
adjusted by the friction knob under the shift
box. Turn the knob clockwise
friction and counterclockwise
friction.
g; Remote-Control
In the Boat
The remote-control
stalled properly for satisfactory
The clamp nearest
positioned correctly as follows:
First move the warm-up
,
shift box to full advance.
(actually this measurement
EXTREME OPPOSITE
pas
ITION
o
" IDLE
POSITION
lever is
to increase
to decrease
Cable Installation
cable must be in-
operation.
the shift box MUST be
lever on the
Now, measure
could range
7-17
36"