Routing Parameters - Mitsubishi Electric MELSEC Q Series Reference Manual

6.9

Routing Parameters

Set a relay station in the own network to transmit data to another network.
Set the routing parameters under one of the following conditions.
• When using the dedicated instruction to perform transient transmission to a different network (
324, CHAPTER 9)
• When using the IP packet transfer function (
For the routing function, refer to the following.
Page 103, Section 4.2.3
● Up to 64 routing information settings are available for one programmable controller.
● Setting the same target network No. is not allowed.
1.
Open the "Setting the Ethernet/CC IE/MELSECNET Routing Information" window in the
programming tool.
Project window
2.
Configure settings with reference to the description below.
3.
Click the
Target Network No.
Relay Network No.
Relay Station No.
238
[Parameter]
button
button.
Item
Set a network No. of another network.
(Setting range: 1 to 239, Default: None)
Set the own network No.
(Setting range: 1 to 239, Default: None)
Set the station No. of the relay station in the own network.
(Setting range for Universal model QCPU: 0 to 120, Default: None)
(Setting range for other than Universal model QCPU: 0 to 64, Default: None)
Page 106, Section 4.3)
[Network Parameter] [Ethernet/CC IE/MELSECNET]
Description
Page